Comtrol Multiport Modems Windows 98 User Manual
Page 14
14
Installing Software: ISA-Bus
Installing the Device Driver
m. Click Yes to continue. Another message appears advising you to shut down
and restart your computer.
n. Click Yes. Then power off your computer.
12. When it is safe to do so (after the computer is powered off). install the adapter
by following the instructions in the Hardware Installation Card.
Note: Pay special attention to the I/O Address DIP switch setting. If the
address you select on the hardware does not match the address selected
in the software, you will need to repeat Step 11 later and shut down and
reboot again.
13. Power on the computer under Windows. The PC should recognize the new
hardware and automatically find and install the software for it. Be patient;
this may take some time.
Note: When the process is complete, the PC creates and displays the
RocketPort/RocketModem program group:
Note: If you selected a RocketModem in Step 7, the PC also launches the
RocketModem configuration program:
Note: (This window is small. You may need to minimize or move other
windows in order to find it.)
14. Verify that the correct board number is checked for any RocketModem
installed.
15. Use the droplist to select the country or geographic region where the
RocketModem will be used.
16. Click OK to close the RocketModem configuration window. Your PC is now
ready for use. No reboot is necessary.
17. If desired, continue with the Advanced Configuration options, below.
To configure RocketModem adapters, go to