Comtrol Multiport Modems Windows 98 - Manual (Page 19)

Installing the Device Driver 19
Adding ISA-Bus Adapters
7. Select Multi-function adapters and click Next. A list of board manufacturers and
models appears.
8. Select Comtrol Corporation. Then select the model of adapter you are
installing.
9. Click Next to continue. The install wizard selects an available I/O address and
IRQ setting.
10. Click Next to continue.
11. Click Finish.
12. Click Yes to shut down your computer. Turn off the power.
13. Set the I/O address DIP switches as described in the Hardware Installation
Card.
14. Install the new adapter.
15. Power on the computer and use the bootable diagnostic to verify that the
board is installed and operating correctly.
16. After the board passes diagnostics, remove the diagnostic disk from the drive
and reboot the PC into Windows.
17. Reset the board basic configuration:
a. Access the System Properties window. (Either double-click on the Control
Panel System icon, or right-click on the My Computer icon and select
Properties.)
b. Select the Device Manager tab.
c. Double-click on Multi-function adapters.
d. Select the new RocketPort/RocketModem and click Properties.
e. Select the Resources tab.
f. Set “Setting Based on” to Basic Configuration 1.
g. Click OK to close the window. A warning message appears.
h. Click Yes to continue. Another message appears advising you to restart
your computer.
i. Click Yes.
18. Shut down and restart the computer, so your changes take effect.