Comtrol Rocket Port - Manual (Page 30)

34 - Configuring COM Port Properties RocketPort Series/RocketModem IV Driver User Guide: 2000564 Rev. A
Device Driver Configuration
Configuring COM Port Properties
This section discusses COM port configuration procedures for RocketPort ports. If
you want to change the starting COM port number on the RocketPort, see
Configuring Device Properties on Page 32.
If your application does not set COM port properties, use the Device Manager to
access Ports (COM & LPT) to change the port parameters. If the application sets
COM port properties, those settings take precedence over Windows COM port
settings. The exception to this guideline is if you use the Override and Lock Baud
Rate to option.
Use the following procedure to change COM port settings on a RocketPort port or
ports.
Do not connect RS-422/485 devices until the appropriate port interface
type has been configured in the driver. The driver default port setting
is RS-232.
1. Open Comtrol Drivers Management Console ( Accessing the Comtrol Drivers
Management Console on Page 27).
2. Highlight the appropriate RocketPort.
3. Highlight the first port you want to configure.
Ok
Click Ok to save the changes made on this page and close
the Comtrol Drivers Management Console.
Cancel Cancels any changes made on this page.
Apply
Click Apply to save the settings on this page. If you do not
click Apply before leaving this page, you will be prompted
to Apply or Cancel the changes.
Device General Tab Description
Caution
RocketPort/RocketModem (Universal PCI) Port General Tab