Adding an adapter (existing installation) – Comtrol Rocket Port User Manual
Page 20
26 - Adding an Adapter (Existing Installation)
RocketPort Series/RocketModem IV Driver User Guide: 2000564 Rev. A
Device Driver Installation
Adding an Adapter (Existing Installation)
Use the following procedure to add an adapter to an existing
installation.
1.
Close any applications that are using serial ports before the device driver
installation.
2.
Install the adapter and connect the interface (Quadcable, Octacable, or
interface box).
If you need hardware installation procedures, see
Do not connect RS-422/485 devices until the appropriate port interface
type has been configured in the device driver. The default port setting
is RS-232.
3.
Click Cancel if a Found New Hardware message appears.
4.
From the Start button, click:
•
Programs> Comtrol> RocketPort EXPRESS INFINITY> Driver Installation
Wizard
•
Programs> Comtrol> RocketPort> Driver Installation Wizard - RocketPort and
RocketModem (Universal PCI)
Caution