Determining the bootloader version, Resetting the devicemaster air – Comtrol DM AIR User Manual
Page 50
50 - DeviceMaster AIR User Guide: 2000365 Rev. C
RedBoot Procedures
Determining the Bootloader Version
Determining the Bootloader Version
Use the following procedure to determine what bootloader version is loaded in the
DeviceMaster AIR.
1.
Establish communications with the DeviceMaster AIR using the serial (Page
47) or telnet (Page 48) method.
2.
At the RedBoot prompt, type version.
The bootloader information will display.
3.
To update the bootloader on the DeviceMaster AIR, make sure that you
download the latest version and see
4.
Type reset to reset the DeviceMaster AIR, if you do not have any other related
Redboot tasks.
Resetting the DeviceMaster AIR
When you have completed your tasks in Redboot, you must enter a reset command
at the RedBoot> prompt for the DeviceMaster AIR to begin operation.
Note: The LEDs on the DeviceMaster AIR will go through the power up sequence.
The unit has completed its reset cycle when the PWR or Status LED is lit
and it stops flashing.
RedBoot> version
Comtrol DeviceMaster Boot Version 1.20
RedBoot(tm) debug environment - built 14:57:53, Jun 21 2004
Platform: Comtrol DeviceMaster (ARM 7TDMI)
Portions Copyright (C) 2000. Red Hat, Inc.
Portions Copyright (C) 2001-2004. Comtrol Corp.
RedBoot>