Toshiba TEC MA-1100-100 SERIES - Manual (Page 8)

DISPLAY
The front display is located at the top of the register just above the
keyboard. The display has two types of display — numeric display and message
descriptors.
r R O N I D I S P L A Y
Numeric Display
■ AMOUNT (8 digits)
DPT (2 digits)
RPT (1 digit)
Displays the numeric data, such as amount, quantity,
etc.
Displays the code which represents each Department Key.
It stays lit when repeating the same department entry.
Displays the repeat department entry count. The count
is indicated from the second entry on, and only the
first digit will be displayed even if the count exceeds
nine.
PLU (3 digits, commonly used with the DPT and RPT digits)
Displays the PLU code when any PLU is entered. It goes
out when repeating the same PLU entry.
Message Descriptors
SLP
ALM
REG
(-)
Lights up when a slip has been properly inserted and set to allow
validation.
It flashes to require a slip insertion when validation compulsion
has been programmed on the transaction key just operated.
Lights up with the alarm buzzer to indicate that the last opera­
tion or numeric entry has resulted in an error. To clear the
error condition, depress the [c]
^^7*
Lights up when sale items have been registered.
Lights up when the I RTN MDSE l , I DOLL DISC I , or any other
key that registers a negative amount has been operated.
It also lights up when the I ST | or one of the total keys has been
depressed and the displayed amount is negative.
It lights up also when an amount is entered in the "Q" mode.
- 4 -