Set lock code, V-chip – JVC AVO56WF30 User Manual
Page 38
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Set Lock Code
Channel Guard and V-Chip settings are protected by a four-digit Lock Code. Your TV comes
pre-set with a Lock Code of “0000”. You may change the code to any four-digit number you
wish. To change the Lock Code, follow the steps below.
Access the onscreen menus by pressing M
enu
on your remote control. You may then either
use the up and down arrows A ▼ to scroll to the INITIAL SETUP menu, or press M
enu
until the
INITIAL SETUP screen appears. Use the A ▼ arrows to move to the Set Lock Code. Press the
•<1
or ► arrows to select.
The Padlock icon will appear. Press Zero on the remote’s 10-key pad to access the LOCK
CODE.
V-Chip---------------------------------------
Use the or ► arrow to change the first digit.
When you have selected the first number, move
to the second digit by pressing the ▼ arrow. You
can change this digit using the ◄ ► arrows.
Repeat this process until all four digits are set.
When you have entered your LOCK CODE, press
▼ to move to FINISH.
Press ◄ or ► to exit.
Notesn lnorder,for.V-,Chip.settings to.take.effect, V-Chip,settings.must be turned ON in .
t|ie.,V-CHi.P menu (page.,35).
You can automaticayy, unblock all of your restrictions,by turning
V-Ch,ip.settings. OFF:in the.'V-CHIP .menu.(page.35). 'You can always.unblock a.restriction by
re-entering the V-CHIP menu and removing the lock icon.
38