Toshiba IK-M41R2 - Manual (Page 9)

When using an automatic iris lens
When using a EE lens of video feed back type, since the EE video signal develops at the
6P terminal "IRIS" located on the front side of the camera, the signal is sent to the EE
lens. When using an iris extension cable (EXC-C2E, etc.), use HR10A-7P-4P (Hirose
Electronics Co. Ltd.) for the connector on the lens side.
NC
(GND)
EE power
supply +12V
(max. 50 mA)
1 NC
EE video signal
0.8±0.15V(p-p)
3 GND
When short-circuiting the EE
power supply accidentally, the
fuse inside the camera is cut
and the EE power supply does
not come out. Be always sure to
take care of the wiring.
- Hirose Electronics Co. Ltd. HR10A-7P-4P
(Connection 1: -I-12V, 2: GND, 3: EE video signal, 4: GND)
;■---- Iris extension cable (EXC-C2E, etc.)
EE lens
Camera control unit
NOTE: 1.
2 .
3.
Make sure power switches of the CCD and TV monitor are at OFF position.
Securely tighten the connectors of camera cable.
When using VCR, connect the video cable from the CCU to the VIDEO IN termi­
nal of VCR.
Read the operation manual before making connections.
Precautions for connections (HR10A-7P-4S).
Plugging
Cable
Unplugging
Cable
To connect the cable of the DC power
supply, hold A position of the plug,
and match the plug guide to the re­
ceptacle guide so that connection can
be done smoothly.
To detach the plug, hold B portion of
the plug and pull it straightforward so
that the plug can be detached easily.
9