Toshiba IK-M41R2 - Manual (Page 7)

0 Iris Ring (The lens is option.)
(0 Focus Ring
® Image Pick-up (CCD)
© Focus Lock Ring
® Portion for Camera Holder
© Camera Cable Terminal
© Camera Cable (Option)
® Camera Cable Connector
® Camera Holder
® Lens Mount
® Picture shooting area
® Camera Head Securing Screw
® Camera connector
® POWER Switch
® CAMERA Terminal
® DC IN/SYNC Terminal*
® VIDEO Terminal
@ DC 12V IN Terminal*
® HD Terminal*/VD Terminal*
® Rubber Feet/Mount Screw
Holes
To get appropriate iris, the aperture size is adjusted by
turning this ring.
The focus is adjusted by turning this ring.
Should be kept from dirt, dust, finger-print, etc.
When the focus lock ring is set, movement of the focus­
ing ring becomes heavy.
This portion is held by the camera holder.
The 'CAM' side of the camera cable is connected to this
terminal.
To connect the camera head and the camera control unit
(CCU).Refer to 'OPTIONAL CAMERA CABLES/LENSES'.
To be connected to 6 Camera Cable Terminal on the rear
of the camera head and to 15 CAMERA Terminal of the
CCU. Before connection, confirm the side ('CAM' or
'CCU') of the cable.
When installing the camera head to a tripod or the like,
use the camera holder.
Used to mount the C mount lens.
Be always sure to keep off dust, finger prints, etc.
Used to mount the camera head
Connector to CAMERA terminal of camera control unit
To turn on/off the power.
The 'CCU' side of the camera cable is connected.
This terminal is to be used for VIDEO output. External
Sync, input.
Note: When the signal is input/output through this DC
IN/SYNC terminal, 'DC 12V IN'/'HD, VD' terminals
(* marked) are not connected.
This output terminal is to be connected to Monitor or
VCR video-in terminal. (BNC pin)
The DC power (12V) is connected to this terminal.
These terminals are used for sync, with external control unit.
Remove four rubber feet, and fix the CCU with screws
(MStype). The screw must not protrude more than 5mm
beyond the inside surfaces of the CCU.