First things first, Step1: unpack the box, Step 2 – RCA VR628HF User Manual
Page 8: Install batteries in the remote control, Step 3: connect your vcr
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FIRST THINGS FIRST
STEP1: UNPACK THE BOX
The following items come packed in the box:
•
VCR
•
Remote control
•
RF coaxial cable
STEP
2
:
INSTALL BATTERIES IN THE
REMOTE CONTROL
Follow these steps whenever you need to install or change the
batteries in your VCR remote.
1. Remove the cover of the battery compartment.
2. Place batteries in the remote, matching the + and - ends of
each battery to the diagram inside the compartment.
3. Replace the cover.
STEP 3: CONNECT YOUR VCR
If you connect your VCR to your home antenna or cable system
and then to your TV, use the VCR's IN FROM ANT and OUT TO TV
jacks for a good signal as shown.
If you have a TV with AUDIOA/IDEO jacks, use the jacks for a
better connection. Refer to the Connections section, toward the
back of the manual.