RCA VR628HF - Manual (Page 38)

RECORDING
USINC TWO VCRS FOR COPYINC AND EDITINC
TAPES
Use one VCR as the playback VCR and the other as the
recording VCR.
1. Turn on the TV and VCRs.
2. Tune the TV to the VCR viewing channel (either 3, 4, or TV's
video input).
3. If you connected your VCR using the IN FROM ANT and OUT
TO TV jacks, tune recording VCR to channel 3 or 4--the one
seleC.ed on the back of the playback VCR.
If you have connected your VCR using the audio/video jacks,
make sure you select the line input on the recording VCR.
4. Insert the tape you want to copy into the playback VCR.
Insert a blank tape with safety tab in place into the
recording VCR.
5. Press PLAY on the playback VCR to begin playback. When you
reach the point on the tape or program where you want to
begin copying, press PAUSE again. You may need to adjust
the tracking.
6. Press the RECORD button, then press PAUSE, on the
recording VCR.
7. Press the PAUSE buttons on both VCRs at the same time to
begin copying the tape.
8. To edit segments that you do not want to copy;
• Press PAUSE on recording VCR to pause copying.
• Locate the next segment you want to copy on playback VCR
by using FWD, REV, and PLAY, and then press PAUSE.
• Press PAUSE on both VCRs at the same time to resume
copying.
9. Press STOP on both VCRs when you are finished.
Caution:
The unauthorized recording of
television programs or other
materials may infringe the rights
of others.
34