Setting up your machine, Setting up your machine -5 – Kenmore 17921 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SETTING UP YOUR MACHINE
1. Install your Kenrnore sewing machine in a
Kenmore cabinet, case or set the machine
on. a sturdy flat surface.
2. Your Kenmore sewing machine has been
thoroughly oiled at the factory. Be sure to
wipe off the needle plate area and bed
plate carefully before sewing a garment.
It is wise to practice on a scrap of fabric
so any surplus oil is absorbed.
3. FOOT CONTROL
Your
machine
is
supplied
with
an
electronic foot control which enables you
to sew very slowly. Even at low speed you
have extra power for the needle to
penetrate through several thicknesses of
fabric. Faster speeds are also easily
controlled.
1. Pull out the foot control from its
storage position under the free arm.
(Fig. 1)
2. Slide pedal lock knob to the right and
the foot pedal will pop up to its
operating position. Push foot control
plug into the cord receptacle on the
foot control. (Fig. 2)
3. Push machine plug into the cord
receptacle at the rear side of the
machine.
Then
connect
power-line
plug into any 110-120 volt A.C. wall
outlet. (Fig.
2)
4. LIGHT/POWER SWITCH
Your machine will not operate unless the
light/power switch is turned on. This
same switch controls the machine power,
sewing light and indicator lights on the
stitch indicator panel and electronic
needle control. If you are interrupted or
stop sewing, turn off the switch.