Picking up bobbin thread – Kenmore 17921 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

1. Raise presser foot lever.

Hold needle thread loosely in left hand

and push. peedle up/down switch two
times or rotate hand wheel toward you

one complete turn.

PICKING UP BOBBIN THREAD

2. Bring bobbin thread up by pulling upper

thread.

3. Pull both threads under and to the back

of the presser foot, leaving 3 to 4 inches
of thread clear.

If ycwj can not pick up bottom thread by

following above steps, then check:

1. Is needle threaded ?

2. Is thread tangled around needle ?

Is bobbin case threaded correctly with

thread going through slots A and B as
shown on page 10, Fig. 4 and 5 ?

4. Is there 4 inches of thread coming from

bobbin case and through slot of needle
plate as shown on page 10, Fig. 6 ?

5. Is thread from bobbin case tangled ?