Kenmore 17921 - Manual (Page 39)

Satin stitch
foot
OVERCASTING
Stitch Selector - AAAAA
Stitch Length - 12-8
Stitch Width - 3-4
Use Overcast Foot.
This is one of the .nnore frequently used
zigzag stitches on garment construction.
You may want to overcast along the raw
edge of each seam allowance or fold the raw
edge toward the garment and stitch.
Stitch so the needle pierces the fabric just
short of the outside edge. Raw or worn edges
of older garments can be overcast to prevent
further raveling.
SATIN STITCHING
Stitch Selector - AAAAA
Stitch Length Dial - Between 0 and 24 (•)
Use metal or plastic Satin stitch foot which is
grooved to permit dense stitching to pass
under it easily.
Closely spaced zigzag stitches are called satin
stitches. This is an attractive stitch used for
appliqueing, bar tacking.
Whenever you are using this stitch, it is well
to remember to loosen the tension of the top
thread slightly. The wider the stitch you
make, the looser the tension should be.
If you are stitching on a very soft fabric, use a
backing of tissue paper or interfacing for a
well formed stitch. Puckering of the material
will be eliminated and the bobbin thread will
not be visible on the right side of the fabric.
As with all special stitches, it is best to make
a sample design on your fabric before starting
the design on the garment.
BAR TACKING
Settings same as Satin Stitching
This stitch is similar to a very short satin
stitch and is used to reinforce points of strain
such as corners of pockets and straps on
lingerie.
Sew 4 to 6 zigzag stitches.
36