beautypg.com

Removing fabric, Top-stitching, Darning – Kenmore 17921 User Manual

Page 34

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

REMOVING FABRIC

First turn the handwheel toward you until the

needle is at its highest position, then raise the
presser foot, draw materials to the rear and
cut off excess thread with the thread cutter
located on the presser bar as shown.

TOP-STITCHING

This is a seam you may want to show off! It's
on the front side of the garment, possibly at
the top of a "kick pleat" or on a lapel, both

functional and decorative. Usually, it's a
simple, forward stitch —with an extra-long
stitch length, or with special thread, match­
ing or contrasting.

DARNING

SETTINGS

Stitch Length - 8 to 10
Pressure Regulator - 0 (DARN)
Zigzag foot or square automatic buttonhole

foot

Stretch fabric between embroidery hoops

with hole centered. Lower presser bar and
sew at a slow speed moving fabric back and
forth with a steady rhythm to cover darning

area. When it is covered, turn fabric 1/4 a
turn and sew layer of stitching across first
layer.

If fabric is thin or badly damaged in hole area,

you may want to put a separate piece under

the hole for reinforcement.

31