beautypg.com

Even feed foot, Important, Adjustalble holder – Kenmore 17921 User Manual

Page 23

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

EVEN FEED FOOT

Thumb
screw

Narrow

hemmer

The even feed foot moves top and bottom
material together evenly and enables you to
sew hard-to-sew fabrics without sliding nor

slipping and with perfect matching. Use it for
sewing leather, ultra suede™, shiny fabrics

(vinyls, patents and satins), bonded fabrics,
pile fabrics and matching stripes, plaids and
patterns. It is not recommended for use when

stretch stitching.

To attach the even feed foot;

1. Raise needle to its highest position.

2. Raise presser bar to its highest position

and guide the even feed foot into position
from rear of machine.

3. Attach presser bar clamp to presser bar

and lift presser foot lock as high as it will
go to hold the foot securely.

4. Attach screw (A) provided with the foot

to needle clamp through fork arm and
tighten it.

Note: Attach the foot in exact order of steps

as written.

IMPORTANT:

To prevent friction and wear, put a drop of oil
at each point indicated by arrows in Fig. 2
and set pressure regulator at 2 or 3 before
using this foot.

Oil after 4 or 5 times usage. Be sure to remove
excess oil by wiping foot thoroughly and sewing
on a scrap of fabric.

ADJUSTALBLE HOLDER

Replace the regular presser foot with the

adjustable holder when using narrow hemmer
and edge stitcher attachment.

Loosen thumb screw and press it forward.
Insert the opposite end into the large hole of
the attachment. Slide the attachment to the
left as far as possible. Adjust as necessary to
the correct position for stitching. Tighten the
thumb screw securely.

20