beautypg.com

Controls, Straight stitching, Zigzag stitching – Kenmore 17921 User Manual

Page 16: Bobbin tension, Jljl-jci

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

CONTROLS

STRAIGHT STITCHING

The good looking appearance of your straight
stitching is, mainly determined by the
balanced tension of the top thread and
bobbin thread. The tension is well balanced
when the two threads lock in the middle of
the layers of fabric when straight stitching.

You can achieve balanced tension by
regulating the Top Thread Tension Control.
If the upper thread appears to be too tight,
dial left (lower numbers) to decrease tension.
If the upper thread is too loose, dial right
(higher numbers) to increase tension.
For most fabrics the tension control shuld be

set in the white zone between 3 and 5.

ZIGZAG STITCHING

Always practice stitching on two layers of the
fabric you will be using.

Make sure that you are using the right size
and type of needle for the fabric. See chart
page 19.

Choose a thread of good quality and type for

your fabric. See chart page 19.

Remember — the wider the zigzag setting,
the more chance for puckering. Reduce the
top tension, if puckering occurs.

The top thread will be visible on the bottom
to varying degrees depending on the thread,
fabric, type of stitch being used and speed of
sewing.

The bobbin thread should never be visible on
the top of the fabric.

THREAD TENSION CONTROL

STRAIGHT STITCH

JUST RIGHT

TOP STITCH

TOO TIGHT

-JLJL-Jci

Decrease tension

TOP STITCH

TOO LOOSE

Increase tension

BOBBIN TENSION

The bobbin tension has been correctly set at
the factory, so you do not need to adjust it.

13