beautypg.com

Hose and -too'l, Leaning carpet, Store – Kenmore 473.8592 User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

.'■

store

:HOSE AND -TOO'L-

Unplug carpet cleaner from electrical outlet.

|1. Slide tool mode lever (A) to the left.

2. Wrap hose around upper hose hook (B) on upper

handle. Press hose into clip (C).

3. Continue wrapping hose down, press into clip (E)

and place behind bottom hose holder (E).

3. Pull hose up and press into clip (C).

4. Wrap around upper hose hook (B), bypassing

clip (D) and push hose end fully into holder (F).

Position upholstery tool (G) over projection (H)

^*^on the back of the upper handle and snap into

place.

^'LEANING CARPET"

No cleaning solution removes all stains .from all
carpets. .Stain .removal .varies..with the type, of
spill, .time passed...before.removal, carpet material
and .carpet type....... . . . . . ■■■...... .

.... .

.........

Remove lightweight furniture (tables, lamps, etc.)

from area to be cleaned. Protect any remaining fur­

niture by pinning up furniture skirts and placing alu­
minum foil or plastic under legs.

Vacuum carpet thoroughly to remove loose dirt,

hair, lint and other debris.

Test for coiorfastness on a hidden area of carpet.
Wet a white cloth or paper towel with some deter­
gent. Gently rub onto a hidden area of carpet. Wait

ten minutes. Blot with white cloth or paper towel

and check for color transfer.

Pretreat spots, stains and high traffic areas with
Spot and Stain Spray. Spray spot or area with Spot
and Stain Spray. Then proceed with the next clean­
ing steps.

Fill solution tank according to directions under

“Operating Instructions”. Use the recommended

detergents in your carpet cleaner.

Plan your cleaning to avoid walking on wet car­
pet. Start at the end of the room farthest from the

exit and work in small sections.

Step on handle release pedal and lower handle.
Turn cleaner ON.

^^Squeeze and hold trigger (A) to release
^■^cleaning solution. Push cleaner forward

SLOWLY, then pull it back SLOWLY.

Let go of trigger and push cleaner over same

area to pick up dirty solution without putting down
more solution. Continue using dry strokes until you
see only a little solution coming up through the noz­
zle (front of cleaner).

Do not make the carpet too wet! Use no more

than two sets of forward and backward strokes
while releasing solution. Always follow with dry
strokes - the more the better.

Listen carefully! When the motor sound changes

(rises in pitch), the recovery tank needs to be emp­
tied. When water has reached its capacity in the

recovery tank, the cleaner will NOT pick up dirty
solution.

Allow carpet to dry. Avoid walking on the carpet
until it is dry. Increased air circulation (open doors,
turn on fans, etc.) will help carpet dry thoroughly to
prevent the growth of mold or mildew.

Vacuum thoroughly after carpet has dried, this
will reduce any shading left by the carpet cleaner’s

brushes.

18

This manual is related to the following products: