beautypg.com

Storing hose and tool, Handle assembly – Kenmore 473.8592 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

HANDLE ASSEMBLY

^^pRemove clean solution tank (A) from carpet

cleaner. Remove hose end (B) from hose holder (C).

Remove bolts and nuts packet taped to

^^^upper handle. With hose hook and cord hook

to back of carpet cleaner, push upper handle (D)
down onto lower handle (E). Push bolts into holes
on front of handle. If bolts will not go through

hole easily, handle is not pushed completely
down.

©

Place nuts (F) in recessed areas on back of

lower handle. Hold each nut in place while

tightening each bolt (G) securely from the front of
the handle with a Phillips screwdriver.

Replace clean solution tank by positioning bot-

^^tom first. Press on top of tank to secure latch in

place.

STORING HOSE AND TOOL

^^Siide tool mode lever (H) to the left. Wrap
^^hose around upper hose hook (I) on upper

handle. Press hose into clip (J). Continue wrapping
hose down, press into clip (K) and place behind
bottom hose holder (L). Pull hose up and press into
clip (J). Wrap around upper hose hook {!), bypass­

ing dip (K) and push hose end fully into holder (M).

Press cord into cord clip (N) on back of han-

^■■^dle. Pull cord tight and wrap cord around cord

hooks (O).

10

This manual is related to the following products: