53u_8_9.pdf, Programming user settings – Braeburn 5300 2H-2C User Manual User Manual
Page 5
8
9
Weekday
Weekend
MORN
DAY
EVE
NIGHT
Time: 6:00 pm
Heat: 70˚ F (21˚ C)
Cool: 75˚ F (24˚ C)
Time: 8:00 am
Heat: 62˚ F (17˚ C)
Cool: 83˚ F (28˚ C)
Time: 6:00 am
Heat: 70˚ F (21˚ C)
Cool: 75˚ F (24˚ C)
Time: 10:00 pm
Heat: 62˚ F (17˚ C)
Cool: 78˚ F (26˚ C)
4 Event
2.5 Setting Your Energy Saving Programs
cont.
2
PROGRAMMING
USER SETTINGS
cont.
NOTE:
If the 5-2 day programming mode was selected during the Installer Setup (Installer Guide section 4.2),
the default program will use the weekday and weekend times and temperatures shown above.
Time: 6:00 pm
Heat: 70˚ F (21˚ C)
Cool: 75˚ F (24˚ C)
Time: 8:00 am
Heat: 70˚ F (21˚ C)
Cool: 75˚ F (24˚ C)
Time: 6:00 am
Heat: 70˚ F (21˚ C)
Cool: 75˚ F (24˚ C)
Time: 10:00 pm
Heat: 62˚ F (17˚ C)
Cool: 78˚ F (26˚ C)
2.5 Setting Your Energy Saving Programs
cont.
2
PROGRAMMING
USER SETTINGS
cont.
• Make sure you select either
HEAT or COOL by pressing the system button as appropriate. You should not
enter a program in the
OFF position.
• If Auto Changeover was enabled during installation the user must select either the
HEAT or COOL mode.
The thermostat cannot be programmed in the
AUTO mode.
NOTE:
Once the thermostat has been programmed the user can return to the AUTO mode if desired.
• Independent program times and programmable fan settings for heating and cooling are not available if
Auto Changeover is enabled.
• When you place the system in the
HEAT or COOL modes of operation, the appropriate indicator will appear in
the LCD display when the system is running.
• When you place the system in the
OFF mode the display will indicate OFF.
NOTE:
If the PROG button is pressed while AUTO is selected,
the thermostat will switch from the AUTO mode to the mode
currently in the display.
NOTE:
If Auto Changeover is enabled in the Installer Options, and
a setting is made in either heating or cooling which violates the
dead band, the opposite mode will adjust up or down automatically
to maintain the dead band spacing, see section 3.2.
SYSTEM
FAN
MO
AUTO
HEAT
AUTO
MORN
AM
SYSTEM
FAN
HEAT
AUTO
MORN
AM
SET
MOTUWETHFR SASU