beautypg.com

Braeburn 1010 User Manual

Braeburn Equipment

background image

MODEL

1010

Builder Series

Non-Programmable

Single Stage Heat/Cool

Thermostat

Compatible with low voltage single stage gas,

oil or electric heating or cooling systems,

including single stage heat pumps. Do not use

this thermostat on applications with voltages

above 30 Volts AC.

© 2004 Braeburn Systems LLC • Patents Pending • All Rights Reserved. Pub. No. 1010-100-005

WARNING!

Important Safety Information

• Always turn off power to the air conditioning or heating system prior to installing,

removing, cleaning or servicing thermostat.

• Read this manual thoroughly prior to installing, programming or operating

this thermostat.

• This thermostat is designed for use with a 24 Volt-AC low voltage single stage gas,

oil or electric heating or cooling systems, including single stage heat pumps.

• Do not use this thermostat on applications with voltages above 30 Volts AC.

• The system must have 24 Volt AC power present for proper system operation and control.

• Wiring must conform to all building codes and ordinances as required by local and

national code authorities having jurisdiction.

• Do not short (or jumper) across terminals on the gas valve or at the heating or

cooling system control board to test the thermostat installation. This could

damage the thermostat and void the warranty.

• Do not select COOL mode of operation if the outside temperature is below 50˚ F

(10˚ C). This could possibly damage the controlled cooling system and may cause

personal injury.

• This thermostat should only be used as described in this manual. Any other use is

not recommended and will void the warranty.

SPECIFICATIONS

1

1

• Electrical Rating: 24 Volt AC (18-30 Volt AC)

1 amp maximum load per terminal

2 amp total maximum load (all terminals)

• Control Range: 45˚ - 90˚ F (7˚ - 32˚ C)

• Accuracy: +/- 1˚ F (+/- .5˚ C)

• Compatibility with low voltage single stage gas, oil or electric heating or cooling

systems, including single stage heat pumps.

• Terminations: R, C, G, Y, W, O, B

USER MANUAL

READ ALL INSTRUCTIONS BEFORE PROCEEDING

CONTENTS

SPECIFICATIONS
INSTALLATION
TESTING YOUR NEW THERMOSTAT
PROGRAMMING USER SETTINGS
ADDITIONAL OPERATION FEATURES
TROUBLESHOOTING
WIRING DIAGRAMS

1

2

3
4
5
6
7

Front