ALTANA Haze-Gard Plus Operating Instructions - Manual (Page 28)

8. Continous Mode In the normal measuring mode,
individual measurements are
started by pressing . In
Continuous Mode, on the other
hand, measurements are repeated
and updated constantly. This lets
you "run" a rather larger area of the
specimen and get an impression of
nonuniform zones.
Continuous Mode is possible only for
a single parameter.
Select
"Continuous
Mode" in the
SET-UP menu.
Select the desired parameter. The
parameter can be changed at will.
The haze measurement needs the
value for total transmittance as a
reference for the measured
specimen. When applicable, a
prompt to this effect will appear on
the display.
set up
trans-
mittance haze clarity
T r a n s m i t t a n c e
M e a s u r e m e n t
P l e a s e p l a c e
s a m p l e a t
h a z e - p o r t
R e a d y : O P E R A T E