A&D Weighing BM-20 - Manual (Page 56)

54 BM series
Calibration test report using an internal mass
Note Calibration test does not perform calibration.
Key operation
1 Press and hold the
CAL key to display CC in and release the key.
2 CC is displayed and the balance is tested automatically.
3 The zero point is measured and the weight value is displayed for a few seconds.
4 Internal mass is weighed and the weight value is displayed for a few seconds.
5 If GLP output is used,
glp is displayed and the calibration test report is output.
6 The balance returns to weighing mode after this test.
Command
This calibration test report can be performed with command TST.
Setting
of "info 1" Setting of "info 2"
AD-8121 printer format General format
Space, ASCII 20h
Terminator, CR , LF or CR
CR Carriage return, ASCII 0Dh
LF Line feed, ASCII 0Ah
Manufacturer
Model
Serial number
ID number
Date
Time
Calibration test type
Zero point value
Target weight value
Target weight
Signature
----------- A - & - D
MODEL ----- BM-300
S/N ----- 01234567
ID ------ LAB-0123
DATE -- 2011/02/20
TIME ---- 12:34:56
CAL.TEST(INT.)
ACTUAL
------- 0.0000 -- g
---- +200.0002 -- g
TARGET
---- +200.0000 -- g
SIGNATURE
-
- - - - - - - - - - - - - -