Using your laser printer 4-3 – Panasonic KX-P4440 User Manual
Page 91
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To assist you in selecting your emulation, please note the following:
Panasonic LP:
In this mode the printer interprets HP LaserJet Series III commands as
the HP LaserJet Series III does.
Diablo:
IBM:
In
this
mode
the
printer
interprets
most
of
the
Diablo
630
commands.
Those
commands that are not interpreted
by the
printer are ignored.
An
example
is
Auto
Backward
Printing
ON/OFF.
Since
the
printer
prints
only in the one direction, this command is ignored.
The print position will be within lAoo" of that from the Diablo 630 since
the vertical and horizontal dot resolution of this printer is 300 dots per
inch.
In this mode the printer interprets most of the IBM Proprinter II com
mands.
Those
commands
that
are
not
interpreted
by
the
printer
are
ignored.
An
example
is
NLQ
ON/OFF.
Since
this
printer
always
prints
in the highest quality, this command is ignored.
The print position will be within lAoo" of that from the IBM Proprinter
II, since the vertical and horizontal dot resolution of this printer is 300
dots per inch.
B
Note:
The printer converts print data to dot data before printing.
An error condition may occur if the total amount of data (including text,
macros,
downloaded
fonts
and
graphic
image
data)
exceeds
the
total
amount
of
RAM
memory
installed.
When
this
occurs,
the
LCD
display
will show “RAM OVERFLOW”.
If this happens, the image density or data amount must be reduced
or the downloaded fonts and macros, if any, may be cleared from
RAM memory.
Using Your Laser Printer 4-3