Panasonic NVG2E - Manual (Page 8)

Setting the Clock
How to Insert the Battery for Clock Operation
The “CR2032” size battery is necessary for the date time and
title to be memorized by the Movie Camera.
1 Remove the lid.
2 Insert the “CR2032” size battery on the Battery Holder with (+)
mark facing upward.
Note;
• If the battery is not inserted or if it is exhausted, the indication
“BACKUP” in the EVF will flash for approximately 10 seconds
when turning the Movie Camera on.
•Before exchanging the battery, turn the Movie Camera oft.
CAUTION FOR BATTERY REPLACEMENT
•The life of the battery is about one year. Inspect and if necessary,
replace the Battery once a year.
• Load the new battery with its polarities (+ and -) aligned
correctly.
•Do not try to short-circuit, recharge or heat the battery and do not
throw it into a fire.
1 When the Date/Time Selector Button is
pushed, the indication shown on the right will
appear in the EVF.
• If no battery is inserted, the indication
“BACKUP” will flash.
2 When the Shift Button is kept pressed for more than about
2 seconds, the “Year” portion will start to flash. Then, at every
press of the shift Button, the items to be set will flash in the
following sequence.
Year-^ Months Date-» Hour-» Minute-»...
3 When the Set Button is pushed, the flashing portion displayed
will be changed in the following sequence.
YEAR: 1990^1991-
MONTH: 1-»2-» ...
DATE: 1-»2-» ...
HOUR: 0^1-» ...
MINUTE: 00^01-» .
»2089-»1990-»
,...-» 12 -» 1 -»
. .. .-»31^1-»
... .-»23-»0-»
. . -»59^00-»
•Repeat procedures 2 and 3 until all items have been set.
•Once the time and date are set, press the Shift Button in
response to a precise time signal so that the clock may begin to
function.
Recording the Date/Time indications
When the Date/Time Selector Button is pushed repeatedly, the
indications will change in the following sequence:
No Indication Date and Time Date