KEYENCE IV Series - Manual (Page 5)

5
5. Click the [Limit Adjustment] button.
6. Set the threshold to judge OK and NG.
7. After the setting is completed, click the [OK] button. The display will
return to the main screen for Position Adjustment tool settings.
8. Click the [OK] button.
9. After the setting is completed, touch the [Next to STEP4] button to
proceed to “STEP4”.
 Setting the output
1. Click the output line to assign the output function.
Output function Explanation
OFF No output assigned
Total Status When the total status result is OK, the output
is ON.
Tot. Status NG When the total status result is NG, the output
is ON.
RUN When the sensor is running with no system
error, the output is ON.
BUSY While the sensor cannot receive the trigger
signal, the output is ON.
Error When an error has occurred, the output is ON.
Pos. Adj. When the position adjustment tool is OK, the
output is ON.
Tool 1 to 16 When the result of the tool is OK, the output is
ON.
Logic 1 to 4 When the result of the logic is OK, the output is
ON.
2. After the setting is completed, click the [Complete] button.
3. Click the [Yes] button.
Start running
1. Touch the [RUN] button.
2. Confirm that the main screen is [Run].
1114-1