Cub Cadet 7532 - Manual (Page 99)

Transmission 5
58
5.3 Removal and Disassembly of
Transmission
Follow the following procedure for removal and
disassembly of transmission.
1. Remove the 3-point link.
1) Remove the snap pin at rear axle housing and
disconnect the stabilizers.
2) Remove the linchpin from lift arm and
disconnect it lift rods LH/RM from lift arm.
3) Remove the linchpin at the mounting point of
lower link and remove 3-point link.
4) Remove the snap pin at top link bracket and
remove clevis pin and top link.
2. Remove the harness and link.
• Rear PTO link
• MID PTO link (Option)
• Range shift link
3. Remove the mounting bolts (9 pieces) for hydraulic
case.
4. Remove the hydraulic case assembly by hoisting.
Lift rod
Stabilizer Stabilizer
Top link Lift arm
Lower link
GZ3W24-007
MID PTO link
GZ3W24-009
Range shift link
Rear PTO link
Hydraulic case assembly
GZ3W24-010