Checkline WT3-200 - Manual (Page 7)

Model WT3-200 Wire Terminal Pull Tester User’s Guide
6
4 HOME SCREEN AND CONTROLS
4.1 Home Screen
No. Name Description
1 Tension /
compression
indicator
- Tension (pull) direction.
- Compression (push) direction. Not typically used.
These indicators are used throughout the display and menu.
2 Peak The maximum measured tension force. This reading can be reset by pressing
ZERO or by powering the tester off and on.
3 Primary reading The current displayed reading. See Operating Modes section for details.
4 Units The current measurement unit. Abbreviations are as follows:
lbF – Pound-force
ozF – Ounce-force
kgF – Kilogram-force
N – Newton
kN – Kilonewton
5 Load bar Analog indicator to help identify when an overload condition is imminent. The
bar increases from left to right, indicating increasing load. If set points are
enabled, triangular markers are displayed for visual convenience. This
indicator reflects the actual load, which may not correspond to the primary
reading (depends on operating mode). The ZERO key does not reset the load
bar. See Operating Modes section for details.
6 Mode The current measurement mode. Abbreviations are as follows:
RT – Real Time
PK – Peak
BRK – Break Detection
See Operating Modes section for details about each of these modes
7 Number of stored
data points The number of stored data points in memory, up to 1000. Displayed only if
Memory Storage is enabled for the DATA key.
1
2
3
5
6 7
8
9
10
11
4