Checkline WT3-200 User Manual
Page 13
Model WT3-200 Wire Terminal Pull Tester
User’s Guide
12
10 COMMUNICATIONS
Communication with the WT3-200 is achieved through the micro USB or 15-pin serial ports located at the
bottom of the instrument, as shown in the illustration in the Power section. Communication is possible
only when the tester is in the main operating screen (i.e. not in a menu or configuration area).
10.1 Installing the USB driver
It is recommended that the USB driver be installed before physically connecting the tester to the
PC with a USB cable.
1. Insert the Resource CD supplied with the tester into the CD/DVD drive in the computer. Then, navigate
in Windows Explorer or My Computer to one of the following folders on the CD:
Windows 2000 through Vista - “Win_2K_XP_S2K3_Vista”
Windows 7 - “Windows_7”
2. Execute the installer application “Mark-10USBInstaller.exe” by double-clicking it. When the program
launches, one of the following windows will appear, depending on the operating system:
or
Click “Install”.
3. The next screen appears as follows:
Click “Continue Anyway”.
4. After installation completes the following screen may appear in non-Windows 7 operating systems.