Brookfield DV-III Rheometer - Manual (Page 7)

Brookfield Engineering Laboratories, Inc. Page 7 Manual No. M/98-211-A0701
2) Insert the mounting handle on the back of the DV-III+ into the hole on the clamp assembly
(Figure 2).
Figure 2
3) Tighten the DV-III+ clamp Screw (Figure 2).
Note: If the clamp assembly moves along the upright rod too freely, tighten the
tension screw (see Appendix F).
4) Insert the ribbon cable into the DV-III+ Rheometer head. Insert the other end of the ribbon
cable into the connector on the DV-III+ base (see Figure 3).
Bubble Level
Rack Gear
Clamp Screw
Clamp Assembly
Upright Rod
Mounting Handle