Refilling or replacing the verification stamp – Panasonic Panafax UF-260 User Manual

Page 112

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Text mode
Original mode

Refilling or Replacing the Verification Stamp

The verification stamp contains ink. When the stamp appears faded or hard to read,
the stamp should be refilled with ink or replaced.

Make sure the battery switch is ON. Then turn the power OFF (O). Remove the

ADF tray and the handset. Stand the machine up. Remove the Bottom Board Unit

Screws and open the Bottom Board Unit towards you.

(a) To refill the stamp with ink, remove the Verification Stamp Unit, and refill the

stamp by placing a few drops of specified ink into it. Give the Ink a few hours
to spread. Make sure that ink does not spill from the stamp when it is turned
over. Then reset the stamp unit.