Panasonic CF-25 - Manual (Page 31)

^ Display
No display after powering
on
' i ^
„ , {
The brightness can be adjusted with
When purchasing the computer the display setting has been preset for an external display 11
you connect an external display the screen is displayed on the external display
When there is no display to an external display,
• Check yoiii cable connection lor the external display
• Confirm your display is on
If your computer is connected to an external display and the internal LCD has been set to
"off and the computer is plaeed m the hibernation or suspend mode the internal LCD
will remain in the "otf mode it the external display is not connected when the computer
IS restarted In this case re-connect the external display and reboot the computer
The power has not been cut,
but after a certain period of
,time, there is no display
# Has the computer been set to the power-saving mode ’
To resume operation of your computer press any key
• To save power, your computer may have automatically entered the hibernation mode
(Q-page ID
An aft^image appears 11 an image is displayed tor a prolonged period ol time an altenmage may appear This is
not a malfunction The afterimage will disappear when a different screen is displayed
The itidtion of the mouse ^
cursor IS not smooth ^
Select [Start j-lSettings]-[Control Panell-[Mouse]-lMotionl and check [Show pointer trails]
# Disk (Disc) Operations
Cannot read/write to a
floppy disk • Has the floppy disk been correctly inserted^
• Has the floppy disk been correctly formatted^
• Your floppy disk drive may not have been properly set in the multimedia pocket
• Has the Setup Utility been used to set [Floppy Operation] to [Enable]^
Unable to write to a floppy
, disk ;
Is the floppy disk wnie-protected ^ 5
How to format a floppy disk
IS
unclear
Select [Format] in [My Computer] - [3 1/2 Floppy (A )] - [File] Alter confirming the disk
volume and format type click restart"'!
Unable to read/write to the
hard disk . ^ i , *
’ k ‘ t y,
• Your drive or file may not have been properly set
• Check to sec if the hard disk is full If it is full delete unnecessary tiles
• Your hard disk content may be corrupted Consult your nearest Panasonic dealer
Setup utility
g IS displayed r
Enter the User Password or Supervisor Password If you have forgotten it consult your
nearest Panasonic dealei
[Supervisor Setup] is not
displayed in the menu
At the start ot the computer when is displayed you have to enter the Supervisor Pass­
word When both the User Password and Supervisoi Password have been set it you enter
the User Password [Supervisor Setup] will not be displayed ( p a g e 40)
If (Supervisor Setup] is not displayed even alter ciiteiing the Supervisor Passwoid you have
to delete the User Password Run the Setup Utility again and input the Supervisor Password
[User Password] cannot be
selected
[User Password Piotection] in [Supcivisor Setup] may be enabled
[Coflee break Password]
or [Key Combination for
CofTee break] cannot he
selected
You need to set tlie User Passwoid
[Supervisor Password]
cannot he set
It the User Password has been set flrst the Supcivisor P.issword can not be the same as the
User Pass wo k I Another passwoid needs to be entered
31