Panasonic CF-25 - Manual (Page 3)

For U.S.A.
Federal Communications Commission R a d i o
Frequency Interference Statement
Note This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules These limits are designed to provide reasonable
protection against harmful interference in a residential
installation TTiis equipment generates, uses and can radiate radio
frequency energy and if not installed and used in accordance
with the instructions may cause harmful interference to radio
communications However there is no guarantee that interference
will not occur in a particular installation If this equipment does
cause harmful interference to radio or television reception which
can be determined by turning the equipment oft and on the user
IS encouraged to try to correct the interference by one or more
of the following measures
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected
• Consult the Panasonic Service Center or an experienced ra-
dio/TV technician for help
Warning
To assure continued compliance use only shielded interface
cables when connecting to a computer or peripheral Also any
changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate this equipment
This device complies with Part 15 of the FCC Rules Operation
IS subject to the following two conditions
(1) This device may not cause harmful interference and
(2) This device must accept any intcrierence received including
iniciference that may cause undesired operation
For U.K.
FORYOUR SAFETY PLEASE READ THE FOLLOWING
TEXT CAREFULLY
This appliance is supplied with a moulded three pm mains plug
for your safety and convenience
A 3 amp tuse is fitted in this plug
Should the fuse need to be replaced please ensure that the re­
placement fuse has a rating of 3 amps and that it is approved by
ASTA o r B S I t o B S 1362
Check tor the ASTA mark or the BSI mark ^ on the body
of the fuse
If the plug contains a removable fuse cover you must ensure that
It IS lefittcd when the fuse is replaced
II you lose the (use covei the plug must not be used until a re­
placement cover IS obtained
A replacement tuse cover can be purchased fioin your local
Panasonic Dealer
I F T H C FITTED MOULDED PLUG IS UNSUITABLE FOR
11 IE SOCKET OUTLET IN YOUR HOME I HEN THE FUSE
SHOULD BE REMOVED AND THE PLUG CUT OFF AND
DISPOSED OF SAFELY
THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK
IF THE CUT OFF PLUG IS INSERTED INTO ANY 13 AMP
SOCKET
If a new plug IS to be fitted please observe the wiring code as
shown below
If in any doubt please consult a qualified electncian
Important
The wires m this mains lead are coloured in accordance with the
following code
Blue
Neutral
Brown Live
As the colours of the wires in the mains lead of this apparatus
may not correspond with the coloured markings idcntilying the
terminals in your plug proceed as follows
The wire which is coloured Blue must be connected to the ter­
minal which IS marked with the letter N or coloured BLACK
The wire which is coloured Brown must be connected to the
terminal which is marked with the letter L or coloured RED
Under no circumstances should either of these wires be con­
nected to the earth terminal of the three pin plug marked with
the letter E or the Earth Symbol ^
The mams plug on this equipment must be used to disconnect
the mams power
Please ensure that a socket outlet is available near the equipment
and shall be easily accessible
How to replace the fuse
open the f u s e compartment with a
screwdriver and replace the fuse
Warnings
• This equipment is not designed for connection to an IT power
system
(An IT system is a system having no direct connections be­
tween live parts and Earth the exposed-conducive-ptuis of the
electrical installation are earthed
An IT system is not pemiiUed wheie the computer is directly
connected to public supply systems m the U K )
• Disconnect the mams plug from the supply socket when the
computer is not in use
This equipment is produced to BS800/1983