Panasonic SC-CH350 - Manual (Page 35)

£J ^1 1 I T^QOO O
^ oob
C 1 J
C3i 1 1 —
To find the beginning of a program
(TPS: tape program sensor) To fast forward or rewind the tape
(Also available from the remote control)
Press the fast-forward/rewind (TPS) button while
the tape is playing.
If the forward side (I>) of the tape is playing;
(TPS)»» 1 ; The tape will play from the beginning of the next
program.
{ -»<(TPS) I : The tape will rewind to the beginning of the present
program. Then the program will play again.
If the reverse side (<) of the tape is playing;
The reverse of the above wilt take place.
While a TPS operation is taking place, the play indicator will flash.
Notes;
The TPS function may sometimes fail to operate correctly in the
following situations:
•When the interval between programs (dead space) is less than
4 seconds,
•When you are playing a tape recorded from a microphone and
there is no dead space between tape programs.
•When there is a particularly low-level passage or silent passages
in the middle of a program.
•When less than 10 seconds remain until the end of the present
program or start of the next program.
•When a tape has been recorded with fade-ins and fade-outs.
(Also available from the remote control)
Press the fast-forward/rewind (tPS) button while
the tape is stopped.
The tape will start moving at high speed in the direction of the arrow
(◄◄, ►►) regardless of which direction mode it is in.
To fast forward or rewind the tape while you are playing a tape in
another deck, press DECK 1/2 button to switch to the nonpiaying
deck, and then press the fast forward or rewind button.
35