Panasonic KX-FP101NZ - Manual (Page 74)

Error Messages
Reports
If your unit cannot send a fax, check the following.
“ The number you dialled is correct.
- The other party’s machine is a facsimile.
If the problem remains, correct it by following the communication message printed on the sending and journal
reports (p. 46, 47).
Communication message
Error code
Cause
&
Remedy
COMMUNICATION ERROR 41-72
FF
• A transmission or reception error occurred. Try again or check
with the other party.
DOCUMENT JAMMED — • The document is jammed. Remove the jammed document (p. 82).
ERROR-NOT YOUR UNIT 54, 59
70
• A transmission or reception error occurred because of a problem
with the other party's fax machine. Check with the other party.
MEMORY FULL
—
• The document was not received due to memory being full.
NO DOCUMENT — • The document was not fed into the unit properly. Reinsert the
document and try again.
OTHER FAX NOT RESPOND • The other party’s fax machine was busy or ran out of recording
paper. Try again.
• The document was not fed properly. Reinsert the document and
try again.
• The other party’s fax machine rings too many times. To send a
fax manually, dial the number, confirm the fax tone, and press
fSTART/SET/COPYl.
• The other party’s machine is not a facsimile. Check with the
other party.
• The number you dialled is not in service.
PRESSED THE STOP KEY —
♦ iSTOPl
was Dressed and fax communication was cancelled.
THE COVER WAS OPENED — • The cover was opened. Close it and try again.
OK — • Fax communication was successful.
74