Panasonic Panafax UF-160 - Manual (Page 45)

PROBLEM SOLVING AND DAILY
CARE_________________________
Information Codes
When something unusual occurs, the display may show one of the information codes
below. These will help you fix the problem.
Information
code
Meaning Action
001
002
Recording paper jam. Remove jammed paper.
(See page 89)
004 Recording paper jam. Remove jammed paper.
(See page 89)
010 No recording paper or
recording paper not set
properly. Reload recording paper.
(See page 90)
020 Thermal Recording Head
temperature is too high. Open the receiving unit for
15 minutes to permit
cooling. When the
information code disappears
from the display, you may
continue the operation you
were performing. If the code
does not disappear, turn off
the power and call your
service man.
030 Document misfeeding. 1. Reload the document
properly. (See page 32)
2. Remove document jam.
(See page 93)
3. Adjust ADF,
(See page 94)
031 Document paper is too long
or jammed.
Document length exceeds 1
meter.
1. Reload the document
properly. (See page 31)
2. Remove document jam.
(See page 92)
039 STOP key was pressed
while sending/copying
documents and remains
more than one page on the
ADF.
Remove the documents
on the ADF (press ISTOPI
when a document is bitten
at ADF). Reload the
document and try again.
Information
code
Meaning Action
060 Cover is open or door Close the Transmission
opened during communi- Guide Unit and Receiving
cation. Unit.
400 During initial handshake, 1. Check with the other
464 receiving station did not party.
respond or communication 2. Reload the document
error occurred. and try again.
402 During initial handshake. Reload the document and
404 communication failure try again.
405 occurred.
432
403 No polling capability at the Ask remote side to set
remote side. “POLLED = ON”.
407 No confirmation from the Wait a few minutes and
468 receiving station for the send again.
469 previous page sent.
408 Remote side confirmation of Wait a few minutes and
409 previous page is illegible. transmit again.
410 Invalid command received.
411 Polling password does not Check polling password.
' 414 match.
412 No data from the transmitting
side. Check with the other party.
415 Polling transmission error. Check polling password.
416 Received data has too many Check with the other party.
417 errors.
418
419
436
490
420 Machine goes to receiving 1. Remote side misdial.
mode, but receives no 2. Check with the other
command from the
transmitting side. party.
12
W
86 87