Panasonic Panafax UF-160 - Manual (Page 20)

i .
Verification Stamp
The verification stamp helps you to confirm successful transmissions by stamping
the bottom of each successfully transmitted page with a small pink mark. Your
machine is preset to STAMP»ON. To set the Verification Stamp to OFF,
1 DOCUMENT SET
S T A M P = O N
2 DOCUMENT SET
2 Enter any number 1-99. If you make an DOCUMENT SET
STAMP=OFF
error, press | CLEAR I and reenter the
correct number.
Ex:®
TOTAL PA0ES=5|
To return to STAMP = ON, press
1 STAMP I again.
You can now dial by pressing ITEL/PIALI
and a full number, a One-Touch key,
IABBR
I and two digits, or I RjEDIAL ].
ноте
1. After changing the Stamp setting, you can
a) return to standby with | STOPl.
b) start a different series of settings by pressing IflESOLUTI ON
I HALF TONE1. MODE PI PTI, or | FUNCTIO n T
2 .To change the preset Stamp position, see page 26 - 29.
ORIGINAL
36
Total Pages
The page number will be printed at the top of each page you send. You can also
set, however, the total number of pages you send so that it will be printed on each
page in addition to the page number, (e.g., 01/05. 02/05, etc.)
1
- НОТЕ
zne
or
DOCUMENT SET
TOTAL PAGES=|
repeatedly.
You can now dial by pressing I TEUDIAL I
and a full number, a One-Touch key,
I ABBR I and two digits, or | REDIAL I .
NOTC
After changing the Total Pages setting, you can
a) return to standby with fSTOP |.
b) start a different series of settings by pressing
fSTAMP
---------- -------- RESOLUTION
HALF TONE I, MODE {ЗШ . o TI f UNCTIONT
I ORIGINAL!.
37