Panasonic Panafax UF-160 - Manual (Page 15)

FAX PARAMETERS
Your facsimile machine has a variety of adjustable FAX parameters. These
parameters, listed in the Parameter Tabie, are normally preset for you and do not
need to be changed. If you do want to make a change, read the table carefully.
Some parameters, such as the Resolution, Contrast, and Verification Stamp
parameters, can be temporarily changed by simple key operations just before a
transmission is made. When the transmission ends, however, these parameters return
to their preset values. Other parameters can only be changed by the procedure
described below.
START 02 ORIGINAL
Q : NORMAL
Setting FAX Parameters
1
and
SET MODE
NO. =1
FAX PARAMETERS
START FAX PARAMETER
NO. =1
Enter a fax parameter number from the
Parameter Table {see pages 28 and 29).
Ex: [Tj and {START} for RESOLUTION.
Enter the new setting value.
Ex: [2] for FINE.
01 RESOLUTION
0: STANDARD
01 RESOLUTION
g:F1NE
26
You can now return to Step 4 to set the
next parameter, or, return to standby by
pressing {STOP I.
0 1 - O E C - 1 9 9 0 1 5 : 0 0
NOTC
1. To cancel any digit entered, press fCLEAR [ in step 5, and then start again from
Step 3.
2. To print out a Fax Parameter List, see page 84.
27