Panasonic NV-J45 Series - Manual (Page 7)

Infra-Red Remote Controller (Cont’d)
Load the batteries as follows:
1
Remove the battery compartment lid.
2
Place the batteries in the battery compartment as
indicated inside the battery compartment.
3
Replace the lid.
How to Operate the Remote Controller
(Digital Scanner)
Press the Digital Scanner On/Off Button to “ON”.
• If no operation is performed for more than 25 seconds
(4 minutes during setting of the clock time), the scanner
will automatically switch over to the power-saving
standby condition and the lamp will go off. (In this case, if
bar codes have already been read but not yet
transmitted to the VTR, the data will be cancelled.)
• When the lamp is not lit, press the button to turn it “ON”
again.
Tracing the Bar Codes____________________________
(A) Place the Remote Controller on the Small Box,
(B) Trace the bar code quickly in the direction of the
arrow.
Small Box
Bar Code
The “Beep”
sound indicates
that the barcode
was read
completely.
Trace the bar code
completely past the last bar.
Note:
The bar codes “VTR 1 ” and “VTR 2" in the column
“REMOTE MODE” on the Programming Sheet cannot be
used with this unit.
•If the bar code “VTR 2” is traced by mistake, transmission
to the VTR becomes impossible. To remedy this
condition, trace the “VTR 1" bar code. (The indication
“VTR 2” in the Display will disappear.)
• Treat the Programming Sheet with care. If the
sheet gets dirty or scratched, the bar code reading
may become impossible.
• Protect the Remote Controller from strong shocks
and vibration. Keep it away from water and places
with high temperature and humidity.
• If the bar code is traced slowly, it cannot be read
correctly.
• When there is no “Beep” sound, the reading of the
bar code is incomplete. Trace the bar code again.
• When using the Programming Sheet, put it on flat
surface: Reading the bar codes while holding it In
your hand or bending it, may result in incorrect
operation.
• Do not deviate from the bar code, nor stop tracing
halfway.
V______________________________________/
Note:
• The infra-red beam should be transmitted directly at the
Infra-red Remote Control Receiver on the front of the
VTR.
• Direct sunlight may interfere with the beam,
• The lightsensing angle of the Infra-red Remote Control
Receiver In the VTR Is about 30° for each side from the
centre.
•The unit should be used within a range of about 7 meters
from the front of the VTR,
Recommendation
After the programming of timer recording(s) is completed,
press the Digital Scanner On/Off Button so that the
indications in the Display disappear, in order to save
battery power.
When the Bar Codes Cannot be Read
Although the lamp in the tip of the Bar Code Reading
Section lights up:
• No figures appear in the Display
• No beep sounds is heard;
The tip of the Bar Code Reading Section is probably
clogged with dirt.
Cleaning
1
Remove the cap of the Bar Code Reading Section.
• Remove dirt and dust from the hole of the cap.
Hole
Cap
Gently wipe the tip of the lamp with a soft cloth.
• Reattach the cap by inserting it until it locks with a
click.
Lamp
<
7
>