beautypg.com

Dubbing (copying) – Panasonic NV-J45 Series User Manual

Page 35

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Dubbing (Copying)

Dubbing (copying) from one video cassette to another.

Preparation

• Make the necessary connections as shown in the

connection diagram.

• Press the VTR On/Off Switches to turn both VTRs on,
• Press the Input Signal Selector on the Remote Controller

to select the “A1 ” programme position (or select with the

Channel Up or Down Button on the VTR),

• Make sure that the Noise Filter/Edit Selector of both the

recording and playback VTRs (if equipped) are in the
“EDIT ON" position. Set these switches to “OFF" for
ordinary use of the VTRs.
(The Noise Filter/Edit Selector is on the front panel.)

1

Place the recorded cassette in the playback VTR and

a blank video cassette with the erasure prevention tab
intact in the recording VTR.

2

Press the Record Button on the recording VTR.

3

Press the Play Button (►) on the playback VTR.

4

Press the Stop Button (■) on both VTRs to stop the

dubbing.

To assure smooth, noiseless cuts when

interrupting the recording, always use the

Pause/Still Button (II).

• To obtain smooth cuts when starting the recording

from the stop mode:

1. Play back the last part of the previously

recorded material to confirm its ending point,
and then press the Pause/Still Button

(I I).

2. Press the Record Button.

(The VTR is still in the pause mode.)

3. To start recording, press the Pause/Still Button

(I I)

again.

► The picture quality of a re-recorded tape is not as

good as that of the original.

NTSC 4.43 Switch

When dubbing an NTSC system tape, set the NTSC 4.43
Switches on both the recording and playback VTR to “ON’

• When the NTSC Switch is set to “ON", PAL signals

cannot be recorded correctly.

NTSC4.43

OFF

ON

<

35

>