Audio dubbing – Panasonic NV-J45 Series User Manual
Page 38
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Audio Dubbing
Note that the original sound will be completely erased
during audio dubbing.
©
0
0
0
©
2 4
Preparation
• Press the Input Signal Selector on the Remote Controller
to select the “A1" programme position (or select with the
Channel Up or Down Button on the VTR).
• Insert a video cassette with the erasure prevention tab
intact.
When a video cassette is already inside the VTR, press
the VTR On/Off Switch to turn it on.
• Turn the TV set on and select the video playback
channel.
Press the Play Button (►) to look for the point where
you want to start the audio dubbing.
Press the Pause/Stiil Button (II) at the exact point
where you want to start the audio dubbing.
Press the Audio Dubbing Button (the indicator will
light up).
AUDIO OUB
AUDIO DUB
o
4
Press the Pause/Still Button (II) once again to
release the tape from pause, and at the same time
start the operation of the audio source. The audio
dubbing will start.
5
Press the Stop Button (■) to stop the audio dubbing.
• When a microphone is used for dubbing, do not
place it near the speaker of your TV to prevent
howling noise (acoustic feedback).
• If the erasure prevention tab of the cassette is
missing, no audio dubbing can be made.
• If audio dubbing is performed on a tape recorded
in the NTSC system, the audio dubbing function
will not work correctly.
(
38
)