Panasonic OMNIVISION PV-S9670 - Manual (Page 22)

Multi-Brand Control Feature
I
The Remote Control may be set up to control some TV. or Cable/DSS Box functions.
Multi-Brand Control Setup
1
Find your TV, Cable or DSS Receiver Brand
Code Number on following page.
2 Setup for TV
and
O © ©
O © ©
© © ©
©
Setup remote.
Hold down TV and enter code
with NUMBERED keys.
Setup for Cable or DSS
Hold down DSS/CABLE and
enter code with NUMBERED keys.
' For code 100 or greater, press the
100 key first, then remaining digit,
e.g. for 102, press 100, then press 0,
and then press 2.
3 Confirm code entry.
Press POWER to turn
selected unit ON or OFF.
See table below for list of
controllable functions in each mode.
Please repeat Multi-Brand Control setup after replacing
remote control batteries.
The remote control will not operate all TVs, Cable Boxes, and
DSS receivers made by manufacturers listed. If you get no
results, your particular brand cannot be controlled.
Using the Multi-Brand Control
After remote control is setup, you can select VCR, TV, or DSS/CABLE for the desired function.
Press VCR or TV or DSS/CABLE on the remote control.
This table shows which buttons are available for each mode.
Available
VCR TV CABLE/ DSS
VCR All Functions VOL UP/DOWN
TV VCR/TV, PLAY, STOP
EJECT, SAP/ Hi-Fi,
DISPLAY, FF, REW,
PAUSE, SLOW, REC,
SPEED, ZERO/ C/A SKIP,
COUNTER RESET
POWER, INPUT,
NUMBERED keys,
ENTER, CH UP/ DOWN.
VOL UP/DOWN
CABLE/ DSS VCR/TV, PLAY, STOP
EJECT, SAP/ Hi-Fi,
DISPLAY,FF, REW,
PAUSE,'SLOW. REC.
SPEED. ZERO/ C/A SKIP,
COUNTER RESET
VOL UP/ DOWN POWER, ENTER,
NUMBERED keys
(except lOOkey),
CH UP/ DOWN
In TV or DSS/ CABLE mode, it may be necessary to press ENTER after pressing NUMBERED keys for channel selection.
22
For assistance, call 1-800-211-PANA(7262).