Panasonic OMNIVISION PV-S9670 - Manual (Page 18)

Timer Recording Using VCR Plus+ System
Auto VCR Plus+ System
Channel Setup
(Part
1
)
In order for VCR to read VCR Plus+ code, some set up is required. Guide
(VCR Plus+) channel number is assigned to each local broadcast and cable
station. Because this number sometimes differs from channel TV receives
station on, it is necessary to program the VCR with local channel information.
To receive VCR Plus+ channels automatically, perform the steps below.
Or, see “Manual VCR Plus+ System Channel Setup" section on page 20.
Display menu.
Press ACTION.*
Display SET UP CHANNEL
1) Press
AW
to
select.
2
7
MENU
SET UP VCR
SET UP FEATURE
SET CLOCK
SET UP CHANNEL
ID I ОМА/LANGUE:ENGL ISH
SELECT:
A T
KEY
SET :► KEY
2) Press ► to
display.
3
------- SET UP CHANNEL ----------
ANTENNA : CABLE
AUTO SET
CHANNEL CAPTION
WEAK SIGNAL DISPLAY : OFF
CABLE/DSS BOX SET UP
VCR PIUS+ CH SET UP
SELECT
SET
END
A T
KEY
► KEY
ACTION KEY
Display VCR Plus+ CH
SET UP.
1) Press AT to
select.
2) Press ► to
display.
4
VCR Plus+ CH SET UP
ЫН1>».ЧЯ1
MANUAL SET
SELECT:A T KEY
SET___ :^_KEY___
Select AUTO SET.
1) Press AT to
select.
2) Press ► to set.
5
VCR PIUS+ CH SET UP
PLEASE ENTER ZIP CODE
ZIP CODE: B-----------
SELECT:
A T
KEY
SET :► KEY
END
:ACTION KEY
Enter Zip Code.
1) Press AT ◄ ►
to select and
enter each
number,
2) Press ► or
ACTION to set.
6
PLEASE SELECT HOW OFTEN
TO UPDATE
EVERY NIGHT
EVERY MONDAY NIGHT
Select When to Update.
1) Press AT to
select.
2) Press ► to set.
End setup.
Press ACTION.
Make sure to leave VCR off
(overnight.) If controllable, leave
your cable box on.
VCR Plus+ System is ...
a feature that allows you to set most items
of a timer recording by simply entering a
special code number (PlusCode
programming number) found in TV GUIDE
and selected newspaper TV listings.
Process of Recording
Programming
Important Note
• “One Time VCR Setup” on pages 6-11 must
be completed before “Auto VCR Plus+
System Channel Setup” can be done.
If any part of setup is incomplete,
a warning screen appears.
• If your VCR connection type changes
from type A to B, on page 6, perform
“To Setup VCR in Case a Cable Box or
DSS Receiver was Installed or
Replaced” section on page 10 before
proceeding with these steps.
• Complete this page only if type B
connection (see page 6.) is used.
2 SELECT/
SET
I A :PLAY
6 T :STOP
◄ :REW
► :FF
1
ACTION
5
7
Make each entry within 5 minutes or VCR will
leave this mode.
Once local channels have been programmed,
they will stay in memory, even in the case of
a power failure.
“ALL SET’ will flash on Multi Function Display
during Auto VCR Plus+ System Setup.
If the start time for a timer recording comes
up during Auto VCR Pius+ System Setup, the
timer recording will have priority. 18
For assistance, call 1 -800-211 -PANA(7262).