Panasonic OMNIVISION PV-S9670 - Manual (Page 19)

‘Important: If the remote control POWER, ACTION, PROG, CHA/v, INDEX/ M/A SKIP, NUMBERED keys,
INPUT, TAPE POSITION, or ADD/DLT button does not work when pressed, press the VCR
button on the remote and try the button again.
Auto VCR Plus+ System
Channel Setup
(Part
2
)
Before you perform the following steps, you should have:
•completed “Auto VCR Plus+ System Channel
Setup (Part 1)” on page 18.
•left VCR off overnight, and turned it back on
after 9:00 AM the next day. 1
If channel updating was
successful.■■
VCR PIUS+ CH SET UP
VCR PIUS+ CH SET
COMPLETED
If VCR could not
distinguish channel map...
END :ACTI ON KEY
VCR PIUS+ CH SET UP
PLEASE SELECT
VCR PIUS+ CHANNEL
NEXT :ACTION KEY
Exit this mode.
Press
ACTION.
Display SELECT
VCR PIUS+ CH.
1) Press
ACTION
to display.
2) Continue
with step 2.
2
SELECT VCR Plus+ CH
KMEX KCAL KWHY KVCR ►
51
1
101
42
5-
99
18
10
110
33
7
78
SELECT;
A T
► KEY
SET :ADD/DLT KEY
END :ACT I ON KEY
Select channel map
for your area.
1) Press AT
◄ ►to
select.
2) Press ADD/
DLT to set.
3
VCR PIUS+ CH SET UP
PLEASE LEAVE VCR OFF
AND CABLE BOX ON
OVERNIGHT
END : ACT I ON KEY
End Setup.
Press
ACTION.
Make sure to leave VCR off
overnight. If controllable,
leave your cable box'on.
Channel map will be updated overnight.
If it was successful. “VCR Plus+ CH SET COMPLETED"
appears on screen. And then, press ACTION to exit.
Repeat these steps as necessary.
If Auto Setup fails, do “Manual VCR Plus+ System
Channel,Setup” on page 20.
Process of Recording
o
Programming
SELECT/
SET
A :PLAY
T :STOP
◄ :REW
► :FF
*| ACTION
3
ADD/
DELETE
To Change or Update Auto VCR
Plus+ System Channel Setup
(E.g. you selected wrong channel map or
zip code.)
a Do “Auto VCR Plus+ System Channel
Setup (Part 1)" steps 1-4 on page 18.
VCR PIUS+ CH SET UP
SELECT VCR PIJS+ CH
SELECT:A T KEY
SET :► KEY
END :ACT I ON KEY
b
Press AT to select UPDATE VCR Plus+
or SELECT VCR Plus+ CH, then press ►.
C If you selected UPDATE VCR Plus+ CH,
perform steps 5-7 in the “Auto VCR Plus+
System Channel Setup (Part 1)” section on
page 18.
If you selected SELECT VCR Plus+ CH.
perform steps 2-3 in the “Auto VCR Plus+
System Channel Setup (Part 2)” section on
this page. 19