Panasonic OMNIVISION PV-S9670 - Manual (Page 20)

Timer Recording Using VCR Plus+ System
(continued)
Manual VCR Plus+ System
Channel Setup
• Before you begin, complete “Channel Setup
Preparations” below right.
Important Note
• If your VCR connection type changes from type A to B, on
page 6, perform “To Setup VCR in Case a Cable Box or
DSS Receiver was Installed or Replaced” section on page
10 before proceeding with these steps.
1
Do “Auto VCR Plus+ System Channel
Setup (Part 1),” steps 1-3 on page 18.
2
VCR PIUS+ CH SET UP
AUTO SET
MANUAL SET
SELECT
SET
END * ▼ KEY
► KEY
ACTION KEY
Select MANUAL SET.
1) Press
AW
to select.
2) Press ►
to set.
IMPORTANT NOTE:
For step 3, use the list you prepared. You may leave lines
blank if you do not receive that station, or If the GUIDE CH
number and the CABLE (or TV) CH numbers are the same.
3
VCR Plus+ CH SET UP
GUIDE CH CABLE CH
► EB
02
SELECT
SET
END i ▼ KEY
► KEY
ACTION KEY
VCR PIUS+ CH SET UP
GUIDE CH CABLE CH
01
02
SELECT
SET
END A ▼ l«Y
<■ KEY
ACTION KEY
Select VCR Plus+
channels.
1) Press ► to
move cursor
to right
column.
2) Press AT to change
CABLE (or TV) CH
number.
3) Press ◄ to set.
4) Press AT to scroll
up/down GUIDE CH
column.
• Repeat step 3 until list is
complete.
To make corrections.
Press AT and ► to move to error, then AT to change,
or ADD/DLT* to erase number.
End setup.
Press ACTION
three times.
Make each entry within 5 minutes or the VCR will leave this mode.
Once local channels have been programmed, they will stay in
memory, even in the case of a power failure.
VCR P1US+, C^ ALL SET, and PlusCode are registered
trademarks of Gemstar Development Corporation. The
VCR PlusH- system is manufactured under license from
Gemstar Development Corporation.
Process of Recording
c> Programming
2
3
SELECT/
SET
AiPLAY
T :STOP
◄ :REW
► :FF
4
ACTION
3
ADD/DELETE
Channel Setup Preparations
In order to complete step 3 left, make a
local channel list (see example below).
You will need the following:
• A line up of normal TV and/ or Cable stations and
the channel number you receive them on.
• A list of Guide (VCR Plus+) channel numbers for
the stations you receive found in TV Guide and
selected newspapers.
1 Make a 3-column chart. In the left column, write
the name of all the stations you receive.
2 In the middle column, write each station’s Guide
(VCR Plus+) number from TV Guide.
3 In the right column, write the channel number
your TV receives the station on.
EXAMPLE ONLY
Broadcast or
Cable
Station Name
Assigned
Guide
(VCR Plus-i-)
channel no.
Channel no.
your TV
receives the
station on
HBO 33
15
Nickelodeon 38 20
CBS 04 04
X FOX 11
20
For assistance, call 1-800-211-PANA(7262).