Panasonic OMNIVISION PV-S9670 - Manual (Page 17)

Important; If the remote control POWER, ACTION, PROG, CHA/T, INDEX/ M/A SKIP, NUMBERED keys,
INPUT, TAPE POSITION, or ADD/DLT button does not work when pressed, press the VCR button
on the remote and try the button again.
Exit program mode.
Press PROG
{or ACTION).
Set timer.
Press POWER OFF.
• When recording programs via a
cable box, make sure the cable
box is left ON and tuned to the
desired channel.
TIMEP
Multi Function Display
— You can also display Program screen from Menu ---------------
1) Press ACTION to display Menu.
• You can also set up using VCR buttons. See the bottom right of the page 16.
2) Press AW and ► to select and set SET UP FEATURE.
3) Press AT to select TIMER PROGRAM and press ► to display
Program screen,
4) Go to step 3 on the page 16.
-------Important notes when using a DSS receiver-------
When recording programs via a DSS receiver, the DSS receiver must
be left on.
When recording programs via an antenna or cable, the DSS receiver
must be turned off.
Review, Replace or Clear Program Contents:
(Recording is not in progress)
Repeat steps 1-2 on page 16.
• If necessary, press POWER ON.
b
P DT START STOP CH SPD
2 8 10 : OOP 12 : OOP 02 SP
3 10 8:OOP 9:OOP 10 SP
4 SU 9:OOP 10:OOP LI LP
CANCEL:ADD/DLT KEY
SELECT
1 - 8 : i T
KEY
Select program.
1) Press AT to
select number.
To Replace program...
b A t SI/ START STOP CH
8 SAT 10:OOP 12:00P 02
rOBAYN ABC
CATEGORY:MOV IE SP
NOTES-STAND BY ME
SELECT START DATE
SELECT:A ▼ KEY
SET
:■ * > KEY.
To Clear program...
ip DT START STOP CH SPD
□----------- ----------- —
2 8 10:00P12:00P 02 SP
3 10 8:OOP 9:OOP 10 SP
4 SU 9;00P10:00P LI LP
SELECT 1-8:* T KEY
_ENTER_:^„ KEY_________
1) Press ► to display.
2) Press AT ◄ ► to
set new program
contents.
1 ) Press ADD/DLT.
End the program.
1) Press PROG (or ACTION).
• If there are programs, press
POWER OFF.
-To cancel Timer Recording-
(Recording is in progress)
Press POWER and then STOP
within 10 seconds to cancel the
Timer recording. (“TIMER” goes
out on Multi Function Display.)
— To review program —
contents on the VCR
Recording is not in progress
Press PROG in Power Off mode.
Every time that butoon is pressed,
the program contents are indicated
in turn on the Multi Function Display.
Recording is in progress
Press PROG. The program
content which advances at
present is indicated on the Multi
Function Display.
( lli
-1 1
i ______
Multi Function Display
h SELECT/
•^SET
A:PLAY
C
T:STOP
◄ :REW
► :FF
d PROG
d ACTION
C
add /
DELETE
17