Leica Geosystems GPS System 500 - Getting Started with Static and Kinematic Surveys User Manual
Leica Geosystems Equipment
Table of contents
Document Outline
- Introduction
- Equipment checklist for Static and Rapid-Static measurements using System 500
- Setting up System 500 for a static survey
- Using the TR500 terminal
- Menus
- Entering information
- Listboxes
- Hardkeys
- Taking Static / Rapid-Static measurements
- Step 1: Power on
- Step 2: Study the icons
- Step 3 (optional): Format your memory card
- Step 4: Begin a survey
- Step 5: Logging raw data
- Step 6: Ending a survey
- Suggested exercise: Measure a very short baseline
- Exploring the sensor status during operation
- Satellite status
- Stop & Go indicator
- Battery and memory status
- Display current navigated position
- Suggested exercise: Get familiar with system status
- Changing the system configuration parameters
- Turning on the illumination of the terminal
- Changing the observation rate
- Setting local time zone
- Changing distance units from meter to feet
- Creating new configuration sets
- Programming Wake-up Sessions
- Kinematic and Stop & Go surveying - using static initialization
- Introduction and general comments
- Equipment setup for Kinematic and Stop & Go surveys
- Carrying out Kinematic and Stop & Go measurements
- Initialization on a known point
- Kinematic "on the fly"
- Practical hints for Kinematic, Stop & Go and Kinematic on the fly measurements
- Miscellaneous
- Appendix: Summary of status icons
- Appendix: Measuring antenna heights