Leica Geosystems GPS System 500 - Getting Started with Static and Kinematic Surveys - Manual (Page 32)

32
Static and Kinematic Surveys-2.0.0en Changing the system configuration
6
7
8
9
3
3
9
3
Setting local time zone, contd. Changing distance units from meter to feet
To change units for distances move
the focus to this input field. Then use
either ENTER to get access to a
listbox from which the preferred
choice can be made; or alternatively
use the cursor left / right keys to
toggle to the units of your choice
(meters, US feet, etc.).
Also other unit parameters can be
changed here, for instance the format
in which dates should be displayed.
Confirm changes by pressing F1
CONT. If you want to exit this panel
without making any changes simply
press ESC to get one level back.
Afterwards press F1 CONT to
activate the selection. You will then
see the correct local time being
displayed in the upper right corner of
the status line.
There is usually no need to modify
initial time or the initial position, even
if the current settings are completely
wrong. The sensor will automatically
enter a "search the sky" mode and as
soon as satellites are tracked time
and position will be updated
automatically.
This can be done in panel CONFIG "3
General / "1 Units". The following
screen becomes accessible: