Leica Geosystems GPS System 500 - Getting Started with Static and Kinematic Surveys - Manual (Page 35)

35
Static and Kinematic Surveys-2.0.0en Programming wake-up sessions
6
7
8
9
13
23
29
33
34
Programming Wake-up Sessions, contd.
Then press the cursor down key to
get access to additional input fields:
If the point list is empty or the point
you want to occupy is not contained
in the list you have to create a new
point by pressing F2 NEW:
You have to enter a Point Id.
Navigate to this input field and press
ENTER in order to get access to the
point management:
Enter a Point Id. You can leave the
coordinates blank (the correct input
of these coordinates is only of
importance for points which should
be used as realtime reference sites):
Press F1 STORE to create the new
point and get back to the previous
display.
Define the configuration set you want
to use. Highlight this input field and
press ENTER. A listbox will appear
from which you can choose the
appropriate configuration set. Make
sure that this set is configured such
that observations will be logged -
otherwise there will be no data
available for subsequent
postprocessing in SKI-Pro.
Define Start Date by typing in the
date when the session should be
executed.
Define Start Time by typing in the
time the session should start.
Define the duration of the session.
The format is hours: minutes:
seconds (hh:mm:ss).