Miscellaneous – Leica Geosystems GPS System 500 - Getting Started with Static and Kinematic Surveys User Manual
Page 46
46
Static and Kinematic Surveys-2.0.0en
6
7
8
9
3
3
9
3
4
7
3
5
6
7
9
Miscellaneous
System 500 supports two levels of
operation modes. Standard and
advanced. Certain parameters are
de-activated in standard mode for
simplicity reasons and therefore
can only be accessed if the sensor
is previously configured to
"Advanced" mode.
System 500 supports a compre-
hensive coding system. By default
coding is deactivated for simplicity
reasons. Point related thematical
coding is possible as well as free
sequential coding.
In Status all measured points of a
job can be viewed.
It is possible to automatically
increment point id's, based on
user- definable templates.
System 500 is equipped with a
calculator function. This can be
found under "3 Applications \ 03
Calculator".
The System 500 sensor firmware
supports a multilanguage concept.
English is the master language
and permanently loaded. Several
local language versions exist
which can be loaded and activated
in parallel. Talk to your local Leica
dealer for details.
Miscellaneous
These guidelines cover only a small
subset of the functionality which is
available on System 500 sensors.
Most of the functionality is used only
in realtime applications.
This chapter lists additional features
which might be of use also for static
or kinematic surveys. Detailed
descriptions can be found in the
Hardware User Manual.
System 500 sensors can be used
without any terminal at all. Sensors
can be preprogrammed in a way
that only the "On"-button has to be
pressed, then everything else is
done automatically, even the
switch-off of the sensor.
System 500 sensors are equipped
with 3 LED's which provide status
information on power, tracking,
and memory. The LED's are visible
when the terminal is not attached
to the sensor.